![Mesqool MS-CR1001 User Manual Download Page 11](http://html.mh-extra.com/html/mesqool/ms-cr1001/ms-cr1001_user-manual_1775468011.webp)
Chapter 10 PRESETTING YOUR FAVOURITE STATION
Presetting AM Station
You can preset up to 10 AM stations. These 10 presets are shown as
preset numbers F01, F02, F03, F04, F05, F06, F07, F08, F09 and F10.
In AM radio mode
, follow step 4 in
"
Radio Operation
"
and tune to the
AM station that you wish to preset.
1. Press and hold the TIME SET/PRO button (1) for more than 2
seconds until the last memorized preset number appears and flashes.
3. You can then choose the preset number that you want to memorize
this station by pressing the HOUR/TU- button (2) or the MIN/TU+ button
(3) to adjust the number.
4. Once the preset number is chosen, it will keep flashing for 8 seconds.
Press TIME SET/PRO button (1) once within these 8 seconds to
save the AM station to the chosen preset number.
The LED display
will stop flashing and change back to show the frequency.
5. If the TIME SET/PRO button (1) is not pressed within this 8 seconds
period, then the LED display will jump back to show frequency, and the
memory storing will not succeed.
6. If the chosen preset number is already memorized with a station, the
above procedure will allow the newly tuned station to overwrite the
originally memorized AM station.
- 17 -
- 18 -
Auto Scanning:
Press and hold either of the 2 tuning buttons,
HOUR/TU- button (2) or MIN/TU+ button (3) for more than 2 seconds to
start auto scan. Scanning will stop automatically when a clear radio
signal is found. Repeat the same procedure by using the same button
until your desired station is found.
To stop auto scanning, press any button once.
Note: In some area where the radio signal is not strong enough, the
scanning process may not be able to stop automatically in the desired
station. In such case, please use the Manual Tuning method to tune to
the desired station according to instruction above.
4. To turn off the radio, press and hold the RADIO button (8) until the
radio is turned off and the LED display shows the time. Under this
status, the FM indicator (13) should be off.
Note 1:
The current station and also the current volume level will be
memorized when the radio is turned off. Once you turn on the radio
again, the memorized station will be broadcast at the memorized
volume level.
Note 2:
For the best FM reception, extend the FM antenna wire to its
full length and vary the direction to capture the strongest signal. Do not
connect the FM antenna wire to an outdoor antenna.
AM/FM
Press and hold these buttons to automatically scan radio station
AM/FM
Press and hold this button
AM/FM
Press these buttons to adjust the number
AM/FM