Mesko MS 7854, User Manual

Page: 6 / 156

6
To extend the life of the unit, drain the condensed water from drain hole (8) before putting the unit into storage at the end of the
season.
DEVICE DESCRIPTION (pictures A and B)
1. Control panel 2. Cold air outlet 3. Signal receptor
4. Remote controller 5. Transport handle 6. Exhaust duct
7. Evaporator inlet 8. Drain plug 9. Air exhaust duct
10. Connector of air exhaust duct 11. Window exhaust adapter
CONTROL PANEL (picture C)
A. Power button B. Fan speed button
C. Mode button D. Timer / Temperature up button
E. Timer / Temperature down button F. Fan low speed indicator
G. Fan high speed indicator K. Cool mode indicator
L. Dehumidify mode indicator M. Fan mode indicator
N. Timer button R. WF – full water indicator
S. Set temperature / Timer display W. Timer indicator
REMOTE CONTROLLER – picture D
The remote controller transmits signals to signal receiver (3).
Button "A" - the appliance will be started when it is energized or will be stopped when it is in operation, if you press this button.
Button "C" - press it to select operation mode: "K", "L" or "M". Suitable indicator will be lighted up.
Button "B" - press it to select fan speed in sequence. Suitable indicator will be lighted up.
Button "D" / "E" - press to set up desired temperature in room or the timer. The display “S” present desired temperature, not present
temperature in room.
Button "N" - press to set the time of automatic off and automatic on.
OPERATION OF THE CONTROL PANEL
COOL / DEHUM / FAN
1. Turn on the device.
a) Connect the device and then the device beeps once.
b) Press the "A" button, then the device will turn on.
c) LED display indicates the set temperature.
2.Choose the operating mode
Press the "C" button to select the desired mode of operation by sequence:
Cooling mode "K" -> Drying mode "L" -> Fan mode "M.”
3. Adjust temperature
The temperature can be set within a range 16°-31°C. Press “D” or “E” button to increase or decrease the temperature by 1°C by
pressing once. The device LED panel shows the target temperature for 5 seconds and then displays the set temperature, not present
temperature in room.