Meru Networks AP822, Installation Manual, Page: 35 / 66

AP Removal from Interlude & Silhouette T-Bar 35
The accessory required for such installation is listed below:
1. Determine the location on the ceiling rails where the AP will be mounted and remove the
ceiling tile.
2. Unpack the T-bar hanger kit.
3. Attach the mounting bar (depicted in Figure 8) to the mounting brace (which looks like a
small handle) with the crossbar of the mounting kit sandwiched between them
4. Locate the 650-00232 15/16" T-Bar Adapter/Wall Mount and attach the AP to the mount-
ing bracket by pressing the bracket's Mounting Pins (shown in Figure 2 on page 9) to the
AP's Receiving Slots and sliding the bracket until it locks in place.
5. Gently press the underside of the AP against the mounting brace and rotate it into place
until the locking mechanism clicks.
6. Attach the legs for the mounting kit to the T-Bars in the ceiling by sliding the clips down
onto each respective bar.Remove the top nut from each leg.
7. Lower the crossbar (with the AP attached) onto the legs and screw the nuts back on top of
the bar.
8. Connect one end of the PoE Ethernet cable to the Ethernet connector on the AP.
The AP822eV2 with plastic cover removed is suitable for use in environmental air-handling space
above a suspended ceiling in accordance with the Section 300-22(c) of the National Electric Code and
Sections 2- 128.12 - 010 (3) and 12 - 100 of the Canadian Electrical Code. Part 1. C22. 1. Note that in
order to comply with these standards, the plastic cover on the AP822eV2 must be removed.
Users shall only apply certified external antennas with plenum-rated cables in this installation.
When installed in air-handling spaces, such as above a suspended ceiling, power the AP822eV2 only
with a PoE not a power supply.
You may need to use thicker tiles to support this installation.
TABLE 9:
Item Model Number Quantity
15/16” T-bar & wall-mount combo
adapter (650-00232) 1
T-bar hanger (Optional)
(840-00071) ACC-MTN-ASCMKIT 1