Meru Networks ap400, Installation Manual

Page: 28 / 47

16 Meru Access Point Installation Guide © 2010 Meru Networks, Inc.
Where to Go From Here
AP400 LED Descriptions
Change LED Appearance
If you want to change the appearance of the LEDS, follow these steps:
1.
From the controller, click Configuration > Devices > AP, and then select the AP.
2.
Select one of these settings for the LED Mode setting:
—
Normal: LEDs are as described above
—
Blink: Sets all LEDs flashing; this is useful to locate an AP
—
Dark: Turns off all LEDs
3.
Click OK.
Where to Go From Here
Now that the AP400 is installed, refer to the Meru System Director Getting Started Guide for instruc-
tions on initializing the hardware. Return to this chapter to check the status of the LEDs once the WLAN
is operational.
LED Function Troubleshooting
Power
off—no power
green—presence of power
Status
off—no power
green—booting stage 1
blinking green and off—booting stage 2
blinking green and white—discovering the
controller
blinking green and blue—downloading a
configuration from the controller
blinking blue and off—AP is online and
enabled, working state
blinking red and yellow—failure; consult
controller for alarm state
If the status LED is blinking red and
yellow, there is an alarm on the AP.
Determine what the alarm is by
clicking Monitor > Dashboard >
Alarms and looking at the AP alarms.
You can also use the CLI commands
show alarm and show log.