V5
25
2-
58
1-
01
1
0/1
6
In combination with 2-gang insert
• With push-buttons
– right push-button: channel 1
– left push-button: channel 2
• With rotary knob
– switch both channels together by rotating or briefly
pressing the knob.
|
If a channel is already switched on, then pressing
the rotary knob will switch this channel off. If both
channels are in the same state, then pressing the
rotary knob will switch both channels together.
Dimming loads
In combination with 1-gang insert
• With push-buttons
• With rotary knob
– by rotating the knob
< 0,5 s
< 0,5 s
> 0,5 s
In combination with 2-gang insert
• With push-buttons
– right push-button: channel 1
– left push-button: channel 2
• With rotary knob
– dim both channels together.
– simultaneously to max. / min. brightness.
|
If the channels have different brightness values
then the difference between these remains con-
stant when dimming to max. / min. brightness.
When one channel reaches the max. / min.
brightness, the difference is reduced until the
common max. / min. brightness is reached.
Controlling blinds
• With push-buttons
– raising/lowering (> 0.5 s)
– up/down in steps (< 0.5 s)
• With rotary knob
– raising/lowering (fast half turn of the knob)
– up/down in steps (slow rotation of the knob)
> 0,5 s
>
> 0,5 s
< 0,5 s
>
> 0,5 s
< 0,5 s
> 0,5 s
Retrieving local light or blind scenes
(Only in combination with 1-gang inserts)
Standard scenes
All devices are delivered from the factory with preset-
tings for a light or blind scene.
1
Retrieve scene: press the left
upper
push-button or
the left
lower
push-button
briefly
.
• The devices of the light scene adopt the saved bright-
ness value.
• The devices of the blind scene initially move to the up-
per position. After a running time of 2 minutes, they
move to the saved position.
Changing and saving local light scenes
(Only in combination with 1-gang inserts)
1
Set the brightness value.
2
Save scene: press and
hold
the left
upper
push-
button or the left
lower
push-button.
All lamps are switched off briefly and then back on again
to indicate that the saving procedure was successful.
Then the lamps adopt the saved brightness value.
Changing and saving local Basic blind
scenes
For Basic blind scenes, you can only save the fixed posi-
tion values of "fully up/down".
1
Move the blind to the upper position and wait for the
running time of 2 minutes until the LED segments go
out.
2
Set the desired position of the blind:
– Position "up": no further settings required
– Position "down": lower the blind
3
Save scene: press and
hold
the left
upper
push-
button or the left
lower
push-button.
The blinds are lowered and raised by one step to indicate
that the saving procedure was successful.
Left upper push-but-
ton:
Light on (100%) / blind up
Left lower push-but-
ton:
Light off / blind down
< 0,5 s
> 3 s
1
2
> 3 s
1
3
2
