5
6
Step 4
Hinged side only ! Remove profile. Take the plastic template and line it up with
each set of marks.Mark the third hole.
Note: Make sure the third hole for each hinge is marked towards the outside
of the enclosure.Drill holes for the hinge with 8mm masonry bit and insert wall
plugs.Ensure wall plugs are flush with the wall.
For Side panel do not use plastic template, drill only the holes marked using U
profile.
4A
4B
4C
8mm
Drill holes for hinge
Insert wall plugs
Step 5
MG8x51PLUG
OUTSIDE
Fitting bracket to the end of track(door side).On bracket( MGVC21 )with no slot
remove cap.Position brackets 8mm inwards from edge of tray. Mark wall through
slot. Drill 6mm diameter hole centre of slot and fix bracket hinge fixing side.
Note: Bracket to Side panel side is not to be fixed! Add a dab of silicone to the
back of the wall bracket and fix with 4x30 screws.
Insert wall plugs
Wall Bracket
5A
5B
6mm
Drill 6mm diameter hole
6mm
5C
5D
4*30 round screw
Keep high side of
bracket facing outside
MG6x30PLUG
Step 6
Loosen both nuts enough to allow the nuts to slide into the grove in the side
panel track.(Note:Do not remove nuts from bolt ). Ensure joint closes fully
and tighten, silicone inside of joint.
Side
Front
Side
Front
fix return
end of treck
6A
6B
Step 7
Insert the glass fixing profile into the side section of the bottom track.
Side
Front
Min.8mm Check
adjustment!
Add a dab of
silicone to the
back of the wall
bracket