E
D
R4 117
2 5/05
3
Manually operating the door
The garage door can be disengaged from the opener to enable the door to
be operated manually.
WARNING Stand clear when releasing the door – if the door
is unbalanced it may move suddenly.
To disengage the opener
Pull the red release cord down.
To re-engage the opener
Push the lever (attached to the red release cord) upwards
and move the door slightly to allow the gear to engage.
The door can be re-engaged in any position.
Operating from a remote control
transmitter
Your remote control transmitter has two buttons. One large button and one small button. You can
control two products with the two buttons. For example a gate opener and a garage door opener.
A press on a remote control transmitter button will open, stop or close the door.
If your remote control transmitter has no ef-
fect, move closer to the opener. Radio signals
can be blocked or reduced by many external
factors. There is a battery inside the remote
control transmitter which requires periodic re-
placement. A fresh battery will give better per-
formance than an old battery.
Release cord & clutch
Clutch lever
Release
cord
Transmitter
buttons
Press cover down
then slide off to
expose battery.
Operating from a push button
or wall box
Push button operation is identical to operation from a transmitter, except that there is no radio
signal to be considered.
Repeated button pushes cause the door to Open, Stop and Close, as described above.
One green push button is on the front face of the opener.
The wall control box buttons have similar functions to your transmitter.
Remove visor clip.