Merit 715E, User Manual

Page: 10 / 28

BEFORE
YOU
BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
ASSEMBLY STEP (CONTINUED)
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
RESISTANCE
KNOB
TENSION WIRE
RESISTANCE
KNOB BRACKET
TENSION
CABLE
PRE-INSTALLED
BOLT & WASHER
TOP KEY HOLE
BOTTOM KEY HOLE
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
G) Pull
TENSION CABLE
out from square hole in console mast.
H) Turn
RESISTANCE KNOB
to highest resistance setting. Place the
TENSION WIRE
into the
BOTTOM KEY
HOLE on the RESISTANCE KNOB BRACKET .
I) While holding the RESISTANCE KNOB BRACKET , pull the RESISTANCE KNOB up to slide it into the TOP KEY
HOLE position on the RESISTANCE KNOB BRACKET .
J) Once the TENSION WIRE is in position, turn the RESISTANCE KNOB to the lowest resistance setting.
K) Slide RESISTANCE KNOB & BRACKET into the CONSOLE MAST and attach using PRE-INSTALLED
BOLT & WASHER .
STEPS G-K (715E ONLY)
715E ONLY