Tire Pressure:
Check tire pressure monthly. The recommended tire
pressure should be maintained at 40 to 45 psi.
!
PTO Driveline:
Lubricate both universal joints after every eight hours of
operation. Lubricate the center portion of the driveline on a yearly basis.
The first lube maintenance should be done in the first 16 to 24 hours of
operation. Then follow a regular schedule of lubing.
!
Lube Recommendation:
Lube cross and bearing every 8 hours of use.
Lube telescoping members yearly.
!!
NOTICE:
Replacement parts are not lubricated. When you receive these parts
in, make sure to lubricate and tighten screws.
!
!
Mechanical Chain Drive:
Keep drive chain tension adjusted to about
¼
”
deflection by loosening the four bolts on the lower bearing, then
retightening. Oil the chain frequently enough to keep a film of oil on the
chain. This must be done through the maintenance portal. Replace shield
after maintenance.
!
Universal Joint:
Remove PTO guard cover and lubricate grease fitting in
the U-Joint every eight hours of use. Check PTO retain bolt and retighten
if necessary.
!!
6.2 Storage of Auger _
!
Make sure that auger is in the full down position. Remove all residual
material from the hopper and auger tubes. Touch up all scratches on the
auger to prevent rusting.
!
Clean and re-lubricate spline on the PTO driveline. Cover with plastic bag
to protect from weather, and place it in the transport latch.
!
Move auger to your storage area, park, and chock wheels.
!
Before using the auger after storage, replace any damaged parts or
decals, remove plastic bag from PTO driveline and re-lubricate, and
conduct general maintenance procedure.
!
!
20
