18
© 2000 Merging Technologies
Sphynx User Manual
Chapter 7 - Settings Menu
The ‘Settings Menu’ allows for Sphynx parameters changes.
To enter the ‘Settings Menu’, push on the M
ONITOR SELECT
button while simultaneously hitting once the
S
YNCHRONIZATION SELECT
button before releasing the M
ONITOR SELECT
button.
Warning: If holding the M
ONITOR SELECT
button for longer than 2s, the Sphynx enters the ‘Display Configuration’
mode, as described in Chapter 6.
Using the S
YNCHRONIZATION SELECT
button, to change the parameter number (1-8) displayed on the OVL leds.
Using the
S
AMPLE
R
ATE SELECT
button, to change the value of the selected parameter (1-8), displayed on the LVL
leds.
Once you have set all parameters as you want, press once the M
ONITOR
SELECT
button to exit the ‘Settings Menu’.
The new configuration is stored and applied immediately.
The different parameters are defined as in the following table:
OVL LED Parameter
LVL LED Value
1
Analog I/O Level
1
Calibrated Level
2
Custom Level
2
Analog Input Dither
(Note 1)
1
No Dither (24 bit)
2
Dither 20 bit
3
Dither 18 bit
4
Dither 16 bit
3
AES-EBU Input SRC
1
Without SRC(24 bit)
2
With SRC (20 bit)
4
AES-EBU I/O DUAL Mode
1
OFF
2
INPUT Only
3
OUTPUT Only
4
INPUT and OUTPUT
5
ODI-B OUT Routing Selection
1
ODI-A IN
2
ODI-A OUT
3 SPDIF OUT
(Note 2)
6
STAND ALONE Mode
1
Normal mode
2
Stand Alone mode
7
WCLK I/O in ‘x2’ SR Mode
1
WCLK @ FS/2
2
WCLK @ FS
Note 1:
Only available on S96\IM Modules.
Note 2:
Not available on CPU Rev. A Version.
Default Ex-factory settings are in bold.
Summary of Contents for Sphynx
Page 2: ......
