7.
Place the Rollback Cap on the top of the shell. You are going to press it down over the top,
but as you do so you need to hold the Advance Knob on top and turn it slightly as you press
down until the winder blade on the inside locks into the top of the takeup reel. Once you feel
it lock into place, you can press down all the way. You'll know the cap is in its proper place
when the hole in its center back lines up with the threaded nut in the shell.
8.
Once the cap is in place, turn the
Advancing Knob a small amount while
watching the film side of the back to
ensure that it is still advancing
smoothly. Note: the Advancing Knob
will sometimes have slack. This is not
a problem: just turn it until it becomes
firm; then it should advance normally.
It takes a fair amount of pressure to
advance; this is normal. However, if
the film appears to be jammed and not
moving, do not force it, or you will
break your winder.
9.
To hold the Cap in place and ensure that it doesn't accidentally pop off during use, screw the
included Thumbscrew into the threaded hole in the back. Do not overtighten this screw. It's
purpose is to prevent the Cap from lifting; it can cause damage if screwed too tight.
