Mercury M48 GT, Owner'S Handbook Manual

Page: 12 / 22

Wheeltech M48 GT electric scooter Part Code: Z40962-00
Owner’s Handbook Page 11 of 11
•
Seat
The seat can rotate 360° and locks in 45° settings. To rotate, push the lever located underneath the
right hand side of the seat and swivel seat. Release the lever and carry on swivelling the seat until it
locks in position.
F
Attention
Return the seat to the forward position before driving.
How to adjust the arm rest width
Loosen the knobs at the back of the seat frame then adjust the arm rest width by sliding the arm rest to the
required width. Re-tighten the knob and repeat for the other arm rest.
How to re-position the seat
The seat can be slid backwards and forwards for a comfortable driving position. To slide the seat, pull the
lever at the front of the seat and reposition as required.
Tiller Adjustment
•
The tiller can be adjusted in to several positions by the following steps:
1. Loosen the knob to adjust the tiller to the position you want
2. Once you have selected the required position, tighten the knob to secure the tiller.
N
Warning
Please hold the tiller before loosening the tiller adjustment knob. Otherwise the tiller may drop, causing
damage and/or injury. Never attempt to adjust the tiller whilst the scooter is in motion.
How to set freewheel mode
•
The freewheel lever is shown by the arrow (in photo right)
•
To put the scooter in to freewheel mode, pull out the freewheel lever.
•
To put the scooter in to drive mode, push the freewheel lever in.
N
Warning
When on a gradient NEVER switch the vehicle to the freewheel mode. The electromagnetic brakes will
not be applied. This may result in damage or injury.
Main circuit breaker (reset button)
When your batteries are drained or if the scooter is heavily worked (because of excessive loads, steep
inclines, or because the scooter is stuck, etc) the main circuit breaker may trip to protect the scooter from
damage. The circuit breaker button will pop out if it has tripped. To reset the circuit breaker, push the
button back in. There are two main circuit breakers to check. They are located at the front of the rear
shroud near the users heels.