MAINTENANCE
66
eng
WATER SEPARATING FUEL FILTER
NOTE: The warning system will turn on when water in the fuel
filter reaches the full level. See
Features & Controls
‑
Warning
System
.
The water separating fuel filter removes moisture and also debris
from the fuel. If the filter becomes filled with water, the water can
be removed. If the filter becomes plugged with debris, the filter
must be replaced with a new filter.
28434
1. Remove and replace filter as follows:
a. Turn ignition key switch to "OFF" position.
b. Disconnect wire at bottom of filter.
c. Remove filter by turning the filter clockwise. Tip the filter
to drain fluid in a suitable container.
d. Lubricate the sealing ring on the filter with oil. Thread on
the filter and tighten securely by hand. Reconnect the
wire to the filter.
IMPORTANT: Visually inspect for fuel leakage from the filter by
squeezing the primer bulb until firm, forcing fuel into the filter.
Steering Link Rod Fasteners
IMPORTANT: The steering link rod that connects the steering
cable to the engine must be fastened using a special washer
head bolt ("a" ‑ Part Number 10‑849838) and self‑locking nylon
insert locknuts ("c" and "d" ‑ Part Number 11‑826709113). These
locknuts must never be replaced with common nuts (nonlocking)
as they will work loose and vibrate off, freeing the link rod to
disengage.
Summary of Contents for Jet OptiMax 110
Page 6: ...vi eng...
Page 12: ...xii eng...
