Fender ’
Champion “600”
•
Mercury Upgrade Kit
19
This project and its documentation is the result of technical investigations made by the engineering staff of
Mercury Magnetics
. The disclosure of the information herein may pertain to proprietary rights and
the furnishing of these documents does not constitute an expresed or implied license to use such materials.
Referring to the chassis schematic on page 11, mark the
new hole locations for the output transformer and choke,
then using a 3/16” drill bit make the 2 holes for the choke
and the 4 holes for the output transformer.
This reference shot shows the 2 holes for the choke and
4 for the output transformer.
Solder the output transformer’s speaker leads in place
(green and green/black wires) as shown.
Solder the “Center Tap” to the filaments (from the power
transformer) into the location shown at R15.
Solder the 2 brown leads from the choke to the circuit
board. They go into the 1/16” holes you made.
Soldered choke leads.
1
1
2
2
2 NEW HOLES
FOR CHOKE
4 NEW HOLES
FOR OUTPUT
TRANSFORMER
Summary of Contents for Champ 600
Page 1: ...VERSION 040711 ...
