Mercury 2003 Marauder, Owner'S Manual

Page: 71 / 233

Note: There are 30 seconds in which to initiate step eight.
8. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLink
t
button. Repeat the press/hold/release sequence
again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.
HomeLink
t
should now activate your rolling code equipped device. To
program additional HomeLink
t
buttons begin with step 2 in the
“Programming” section. For questions or comments, please contact
HomeLink at
www.homelink.com or 1–800–355–3515.
Operating the HomeLink
T
Universal Transceiver
To operate, simply press and release
the appropriate HomeLink
t
button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
Homelink
t
at www.homelink.com or 1–800–355–3515.
Erasing HomeLink
T
buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
•
Press and hold the two outer
HomeLink
t
buttons until the red
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
t
is now in the train (or
learning) mode and can be programmed at any time beginning with step
2 in the
“Programming” section.
Reprogramming a single HomeLink
T
button
To program a device to HomeLink
t
using a HomeLink
t
button previously
trained, follow these steps:
Driver Controls
70