VESSEL MOUNTED WATER-SEPARATING FUEL FILTER
This engine requires a vessel mounted water‑separating fuel filter. The filter
should be replaced annually or every 100 hours, whichever occurs first.
!
WARNING
Fuel is flammable and explosive. Ensure that the key switch is off and the
lanyard is positioned so that the engine cannot start. Do not smoke or allow
sources of spark or open flame in the area while servicing. Keep the work
area well ventilated and avoid prolonged exposure to vapors. Always check
for leaks before attempting to start the engine, and wipe up any spilled fuel
immediately.
Filter Replacement
1. Close the fuel valve, if equipped.
2. Place a container under the fuel filter.
3. Remove the water‑in‑fuel sensor and allow the filter to drain into the
container. The liquid that has drained from the filter must be disposed of
according to applicable regulations and law.
a -
Water‑separating fuel filter
b -
Water‑in‑fuel sensor
4. Remove the filter by turning it counterclockwise. Dispose of the filter
according to applicable regulations and law.
5. Lubricate the new filter seal with oil. Do not use grease.
6. Install the filter and tighten securely.
7. Lubricate the sensor O‑ring with clean engine oil.
8. Install the water‑in‑fuel sensor and tighten it to the specified torque.
Description
Nm
lb‑in.
lb‑ft
Water‑in‑fuel sensor
2.5
22.1
–
a
b
57245
MAINTENANCE
eng
77
Summary of Contents for 200 Verado FourStroke
Page 2: ...eng...
Page 6: ...eng iv...
