2019r0
Page 24 of 82
Mercury 2+ Operator Terminal User Manual
In Setup mode, the Mercury 2+ is configurable for system
operation and communication with the host computer. Setup is
selected from the keypad only and, while in setup mode, no
characters are transmitted by the terminal. Parameters and options
are listed on the Setup menu.
Access Setup by pressing SHIFT four times, then ENTER. (On
the S600 keyboard, the SHIFT key is invisible and is located
below the ‘F4’ key and to the left of the '4' key).
If the Security Code has been enabled, the prompt on the LCD asks
for a six figure security code. If no code is entered, the options
menu can be viewed but not configured.
The first parameter and variable of the Setup menu is displayed on
the bottom line of the LCD.
Use the ▲ and ▼ keys to move the cursor to the required
parameter, and the keys ◄► to select an option. (On the Terminal
Automation keyboard, the ▲▼◄► keys are not indicated. The
user must use H, T, M, O instead).
Continue selecting parameters and options until the configuration
of the terminal is complete. Press ENTER, and the selected
options are entered into nonvolatile memory.
Parameters and options available are listed in Table 1 and
described below. Default settings on cold start appear in bold.
Performing a cold start will restore all default settings and erase
any stored messages. A Cold Start can be performed in one of
three ways:
1.
Power on holding down the two leftmost and two rightmost
keys on the bottom row.
2.
In Setup mode, press the bottom left key (i.e. 'O', STOP,
VIEW ALARM). This will display the message "Cold Start?
NO". Pressing the same key will toggle between "Cold Start?
NO" and "Cold Start? YES". If "YES" is shown, pressing
ENTER will cause the machine to pause and then perform a
cold start. To return to setup mode, press ENTER when
"NO" is displayed.
Should these methods fail for some reason, there is a third method
that is guaranteed to work unless the Mercury 2+ is damaged.
However, this requires that the Mercury 2+ is partially dismantled,
which breaks the rear seal, and incorrect reassembly can lead to
water ingress, so please contact the factory before attempting this
method.
3.
Power on with link LK10 set to right hand position (i.e. ‘1’)
then replace in left hand position for normal operation.
Setting options
Cold Start
Entering
Set-up Mode
