AMD Series User Manual
INTRODUCTION:
Thank you for choosing Mercury AMD series distribution amplifier. It is designed to amplify weak
FM/DAB/TV aerial from aerial and distribute to multiple outputs, ideal for domestic or commercial use
to distribute FM/DAB/DTV(DVB-T, ATSC, ISDB, T-DMB)/Sat signal to different room/area.
PRODUCT FEATURES:
-
Separate dedicated inputs for VHF and UHF signal.
-
Built in low noise high gain amplifier to boost weak signals from aerial.
-
Built in mixer to give wideband VHF and UHF output.
-
Integrated LTE signal filter avoids interference and channel loss from 4G mobile signal.
-
Full gain output to for a long cable run.
-
DC pass allows the control of satellite via Magic Eye remote extender (124.157UK)
-
Built in surge and short circuit protection, and maximum output limiter prevents overload.
SPECIFICATION:
AMD02
AMD04
AMD06
AMD08
Item ref
130.030UK
130.031UK
130.032UK
130.033UK
No of inputs
2
2
2
2
No of outputs
2+Full
4+Full
6+Full
8+Full
Frequency
response
47-300MHz,
470-862MHz
47-300MHz,
470-862MHz
47-300MHz,
470-862MHz
47-300MHz,
470-862MHz
Max output level
94dBµV
90dBµV
87dBµV
87dBµV
Gain per split
12dB
8dB
8dB
8dB
Gain on Full
20dB
20dB
20dB
20dB
Noise
<4dB
<4dB
<4dB
<4dB
Isolation loss
22dB
22dB
22dB
22dB
Dimensions
134.5 x 70 x
44.4mm
179.5 x 70 x
44.4mm
224.5 x 70
x 44.4mm
269.5 x 70
x 44.4mm
Weight
270g
350g
420g
500g
INSTALLATION:
Before installing please ensure all devices to be connecting to the amplifier are switched off and
disconnected to the mains. The unit is designed to be connected via “F” connectors for secure
connections, for coax connector (RF/IEC 169-2/Belling-Lee), a coax to “F” connector adaptor will be
required. At the back of the case there are two mount holes which allow unit to be wall mounted.
AMD distribution amplifiers are designed to amplify weak signals and distribute them to different
locations. For installations that are close to TV transmitters, some user may experience blocking or a
frozen picture. An attenuator may be required to reduce the input signal to the amplifier.
