Mercury Racing VesselView, Installation, Calibration & Operation Manual

Page: 150 / 190

Section 7 - Environment and Navigation Menu
90-8M8022154 APRIL 2008 Page 143
IMPORTANT: Depth is measured from the depth transducer location. To measure from
the keel or waterline, set a depth offset in the "Offsets" screen of the "Settings" menu. Refer
to
Section 4 - Settings
for more information.
4. Use the left or right arrow on the arrow trackpad to set the depth at which you wish to
receive a shallow alert.
5. Press the down arrow on the arrow trackpad to proceed to the "DEEP" field.
6. Use the left or right arrow on the arrow trackpad to set the depth at which you wish to
receive a deep alert.
7. Press the check button to confirm your selections.
Viewing Trip Log Information
The "TRIP LOG" screen displays the time, mileage, and average performance since the
last reset.
a
b
c
d
e
f
g
27280
a - Trip time
b - Distance traveled
c - Fuel used
d - Fuel economy
e - Fuel remaining
f - Average speed
g - Engine run time
• Trip time is the amount of time the VesselView has been operated since the last reset.
• Fuel economy displays the average fuel use since reset. By default, this is calculated
in miles per gallon.
• Fuel used is the total amount of fuel used from all tanks since the last reset.
• Average speed displays the average vessel speed since the last reset.
• Distance shows the distance traveled since the last reset.
• Run time shows the total hours the engines have been running since the last reset.
• Fuel remaining is the total fuel amount left in all tanks. This amount cannot be reset.