02 4047 0777
www.mercs.com.au
02 4047 0788
2
MerCs Strider M8
ME-PM-630MCT-2T
MerCs Pty Ltd, 55 Pendlebury Rd, Cardiff, NSW, 2285, Australia | 2019 V1.1
Selects the Voltage and
Current display screens. In
Set-up Mode, this is the “Left”
or “Back” button.
Select the Frequency and
Power factor display screens.
In Set-up Mode, this is the “Up”
button.
Select the Power display
screens. In Set-up Mode, this is
the “Down” button.
Select the Energy display
screens. In Set-up mode, this is
the “Enter” or “Right” button.
Measurements
The buttons operate as follows:
U/I
ESC
M
P
E
Pulse output
Two pulse outputs that pulse measured active and reactive energy.The Pulse 2 constant for active energy is 3200imp/kWh. (Terminals 11 & 12) The
pulse width for Pulse 1 can be set from the set-up menu (Terminals 9 & 10).
The first screen lights up all display seg-
ments and can be used as a display check.
Software version information
The interface performs a self-test and in-
dicates the result if the test passes.
Start-up Screens
*After a short delay, the screen will display active energy measurements.
C1C2
Phase to neutral voltages
Current on each phase.
Phase to neutral voltage THD%.
Current THD% for each phase.
Voltage and Current
Each successive press of the button selects a new parameter:
U/I
ESC
