MerCruiser Sterndrive 350 MAG MPI, User Manual

Page: 92 / 148

Section 5 - Maintenance
Page 84 90-864195061 NOVEMBER 2006
INSTALLATION
1. Install a new water‑separating fuel filter element into the filter cup. Push the element
into the cup until completely seated.
2. Install new O‑ring on the filter cup.
3. Attach the filter cap to the filter cup by grasping the filter cap and rotating it in a counter
clockwise direction while holding the filter cup stationary, until the filter cap locks
securely into place.
4. Install the fuel filter assembly slowly into the Cool Fuel Module to prevent spilling fuel,
and align the screws retained in the filter cap with the screw holes in the Cool Fuel
Module. Tighten the filter assembly retaining screws until hand tight.
5. Ensure that the filter cap is firmly seated against the Cool Fuel Module and torque each
filter assembly retaining screw.
Description Nm lb. in. lb. ft.
Filter assembly retaining screw 6 53
6. Open fuel supply valve, if equipped.
7. Reconnect the Cool Fuel Module harness to the engine wiring harness.
8. Properly ventilate the engine compartment.
!
CAUTION
Overheating from insufficient cooling water will cause engine and drive system damage.
Ensure that there is sufficient water always available at water inlet holes during operation.
9. Supply cooling water to the engine.
10. Start the engine. Check for gasoline leaks around the fuel filter assembly. If leaks exist,
stop the engine immediately. Recheck the filter installation, clean spilled fuel and
properly ventilate the engine compartment. If leaks continue, stop engine immediately
and contact your authorized Mercury MerCruiser dealer.
Lubrication
Steering System
!
WARNING
Do not grease the steering cable while it is extended. Hydraulic lock could occur and
cause loss of steering control.
NOTE: If steering cable does not have grease fitting, inner wire of cable cannot be greased.