Merco 2TSW-2624, Operator'S Manual

Page: 5 / 8

EZ TUBE INSTALLATION AND REPLACEMENT INSTRUCTIONS
CAUTION:
Prior to replacing a heat tube, make sure the contact is clean. If it is burnt or dirty, replace
the socket.
NOTE:
These instructions are based on the unit laying on a work surface upside down.
CAUTION:
Be sure the tube is centered in the socket terminals before placing the warmer in the upright
position and turning on power.
Remove the tube guard by pushing 1.
against the face of the warmer with left
thumb and “bowing” the cross brace up-
ward with your right hand. Pull the brace
free. Remove the lengthwise brace.
2. Place the left tip of the tube under the
white socket (receptacle of the terminal).
Raise the tube into the socket and apply
enough inward pressure to compress the
terminal slightly.
3. While keeping the tube compressed into
the left terminal of the socket, position
the right end of the tube directly beneath
the right socket. 4. Raise the tube into direct alignment with
the center of the right terminal. Release
grip slowly allowing the compressed left
socket (terminal) to lock tube into posi-
tion.