Step 2
11 x 50mm screws
2
5
Fix the corners with 2 x 50mm
screws as shown in diagram.
Do not secure the building to the
floor until the roof is fitted. Fix
the panels onto the floor using
50mm screws in alignment with
the floor joists.
50mm
screw
1
4
*Before fixing the door gable, check
the top and bottom of the door and
remove any transit screws . Make sure
door opens and closes freely. Adjust
hinge position if necessary.
Step 3
Fix door gable and Plain sides
using same method shown in
step 2.
Position the panels so there is
equal spacing between the floor
and cladding on all four sides.
17 x 50mm screws
8 x 30mm screws
9
20
30mm
screw
Place the roof support bar in
between the front and back panels.
Ensure the top corners of the
support bar are flush with each top
point. Secure in place using the L
Bracket on each end with 4x30mm
screws.
Step 4
40mm
screw
30mm
screw
6 x 30mm screws
24 x 40mm screws
8
3
Step 5
Fix an eaves frames to each
sheet using 3x30mm screws
per eave.
Fix the roof sheets to the roof
using 40mm screws directly
through the OSB into the
framing.
