Mercedes-Benz V 200 4MATIC 2015 Operating Instructions Manual Download Page 157

Page: 157 / 360

If you have set continuous operation as the

operating duration and you switch off the igni-

tion, the auxiliary heating switches off auto-

matically after about 15 minutes. If, in the

remaining time, the ignition is switched on

again, continuous operation of the auxiliary

heating continues.

Setting a departure time

You can set three preselection times using the

timer.
Make sure that the time and date set on the

timer are correct before setting the departure

time (

page 154). Otherwise, the auxiliary heat-

ing may switch on at the wrong time and at an

unsuitable location. When setting the departure

time, also observe the important safety notes on

operating the auxiliary heating (

page 145).

Once the departure time is activated, the auxil-

iary heating system starts up automatically and

runs for the operating duration set prior to

departure.
If you set identical departure times (time and

day of the week) for the three preselection

times, only the last time set is saved.
After a malfunction or if the battery has been

disconnected, you must set the departure times

again. You can find further information on mal-

functions in the "Problems with the auxiliary

heating" section (

page 157).

Press the

button until the

symbol in the menu bar flashes.

Press the

button.

In the program column, the

preselection

memory numbers appear. The selected pre-

selection time flashes.

Press the

button to select the

desired preselection time.

Press the

button.

The preselection time is selected. The days

are shown.

Set the day and time as described in the "Set-

ting the day, time and operating duration"

section (

page 154).

The departure time is stored. The program

column disappears. In the display panel, the

message and the

symbol appear.

Press the

button.

The operating duration flashes.

Press the

button to set the

minute value (10 to 120).

Press the

button.

The operating duration for the preselection

time is saved. The time and number of the

selected preselection memory are shown.
The preselection memory that will be activa-

ted next is underlined. Additionally, the day

that is set appears.

Deactivating departure times

Carry out the steps as described in the "Set-

ting the departure times" section

(

page 155).

If the

symbol in the status bar is shown:

Press the

button until the

off

message in the display panel is shown.

Press the

button.

The departure time is deactivated. The time is

shown.

Setting the heating level

You can set the heating level to a range between

10 and 30.
The heating level corresponds to a preselection

temperature for the vehicle interior. This is a

guide value and may, depending on the outside

temperature, differ from the interior tempera-

ture.

Press the

button until the

symbol in the menu bar flashes.

Press the

button.

The heating level display flashes.

Using the

and

buttons, set the

desired heating level to a range between 10

and 30.

Press the

button.

The heating level is set and the

symbol

appears.

Replacing the remote control battery

WARNING

Batteries contain toxic and corrosive substan-
ces. If batteries are swallowed, it can result in
severe health problems. There is a risk of fatal
injury.
Keep batteries out of the reach of children. If
a battery is swallowed, seek medical attention
immediately.

Operating the auxiliary heating system

155

Climate control