Mercedes-Benz SL 55 AMG, Operator'S Manual

Page: 250 / 474

248
Controls in detail
Useful features
Programming or reprogramming the in-
tegrated remote control
Step 1:
왘 Switch on the ignition ( 컄 page 36).
Step 2:
왘
If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise, press
and hold the two outer signal transmit-
ter buttons
2 and 4 and release
them only when indicator lamp 1 be-
gins to flash after approximately 20
seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and/or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3.
Step 3:
왘
Hold the end of the hand-held remote
control transmitter
6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping the indicator lamp
1 in view.
Step 4:
왘 Using both hands, simultaneously
press the hand-held transmitter
button
5 and the desired integrated
signal transmitter button ( 2 , 3
or 4 ). Do not release the buttons until
completing step 5.
The indicator lamp 1 on the integrat-
ed remote control will flash, first slowly
and then rapidly.
Step 5:
왘
When the indicator lamp 1 flashes
rapidly, release both buttons.
Step 6:
왘
Press and hold the just-trained inte-
grated signal transmitter button and
observe the indicator lamp
1 .
If the indicator lamp 1 stays on con-
stantly, programming is complete and
your device should activate when the
integrated signal transmitter button is
pressed and released.
i
The indicator lamp 1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after 20 sec-
onds.