X
Remove filler hose
B
and connector
=
from
the bottom section of the tire inflation com-
pressor housing
;
.
X
Slide the yellow filler hose connector into the
mounting on yellow cap
A
of tire sealant filler
bottle
:
until the connector engages.
X
With the sealing rings in front, slide yellow cap
A
of tire sealant filler bottle
:
into the
mounting of tire inflation compressor
;
. The
cap must engage in both hooks.
X
Remove the cap from valve
C
on the faulty
tire.
X
Screw filler hose
D
onto valve
C
.
X
Insert connector
=
into a socket in your vehi-
cle.
Cigarette lighter socket: (
Y
page 275)
12 V socket: (
Y
page 276)
Observe the notes on the cigarette lighter
(
Y
page 275). Observe the notes on sockets
(
Y
page 276).
X
Turn the SmartKey to position 1 in the ignition
lock (
Y
page 131).
X
Press on and off switch
?
on the tire inflation
compressor to ON.
The tire inflation compressor is switched on.
The tire is inflated.
First, tire sealant is pumped into the tire. The
pressure may briefly rise to approximately
500 kPa (5 bar/73 psi).
Do not switch off the tire inflation com-
pressor during this phase.
X
Let the tire inflation compressor run for a
maximum of ten minutes. The tire should then
have attained a pressure of at least 200 kPa
(2.0 bar/29 psi).
If a pressure of 200 kPa (2.0 bar/29 psi) has
been attained after five minutes, see "Tire pres-
sure reached" (
Y
page 304).
If a tire pressure of 200 kPa (2.0 bar/29 psi) has
not been attained after five minutes, see "Tire
pressure not reached" (
Y
page 303).
If tire sealant has escaped, clean it off affected
areas as quickly as possible. Use plain water if
possible.
If your clothes are soiled with tire sealant, have
them cleaned with perchloroethylene at a dry
cleaner as soon as possible.
Tire pressure not reached
If a tire pressure of 200 kPa (2.0 bar/29 psi) has
not been attained after ten minutes:
X
Switch off the tire inflation compressor.
X
Unscrew the filler hose from the valve of the
faulty tire.
Note that tire sealant may escape when you
unscrew the filler hose.
X
Very slowly drive forwards or reverse approx-
imately 30 ft (10 m).
X
Pump up the tire again.
After a maximum of ten minutes, the tire pres-
sure must be at least 200 kPa (2.0 bar/
29 psi).
G
WARNING
If the required tire pressure is not reached
after the specified time, the tire is too badly
damaged. The tire sealant cannot repair the
tire in this instance. Damaged tires and a tire
pressure that is too low can significantly
impair the vehicle's braking and driving char-
acteristics. There is a risk of accident.
Do not continue driving. Contact a qualified
specialist workshop.
Flat tire
303
Bre
akdow
na
ssistance
Z
Summary of Contents for MY17 c-class
Page 353: ...351 ...
Page 354: ...352 ...
