G
WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
(
Y
page 238).
Garage door remote control
A
is not inclu-
ded with the integrated garage door opener.
X
Set the Start/Stop button to key position 2
(
Y
page 122).
X
Select one of buttons
;
to
?
to control
the garage door drive.
X
To start programming mode: press and
hold one of buttons
;
to
?
of the inte-
grated garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp
:
begins to light up yellow.
Indicator lamp
:
lights up yellow immedi-
ately the first time button
;
,
=
or
?
is
programmed. If the selected button has
already been programmed, indicator
lamp
:
lights up yellow after ten seconds
have elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
To program the remote control: point
garage door remote control
A
towards
buttons
;
to
?
on the rear-view mirror at
a distance of 5 to 20 cm.
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green:
programming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is
to synchronise the rolling code
(
Y
page 239).
X
Release button
B
of remote control
A
of
the garage door drive.
If indicator lamp
:
lights up red: repeat the
programming process for the correspond-
ing button on the rear-view mirror. When
doing so, vary the distance between remote
control
A
and the rear-view mirror.
The required distance between remote
control
A
and the integrated garage door
opener depends on the garage door drive
system. Several attempts may be required.
You should test every position for at least
25 seconds before trying another position.
Synchronising the rolling code
Observe the "Important safety notes"
(
Y
page 238).
If the garage door system uses a rolling code,
you will also have to synchronise the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this you
will need to use the programming button on
the door drive control panel. The program-
ming button may be placed at different loca-
tions depending on the manufacturer. It is
usually located on the door drive unit on the
garage ceiling.
Familiarise yourself with the garage door
drive operating instructions, e.g. under "Pro-
gramming of additional remote controls",
before carrying out the following steps.
Your vehicle must be within range of the
garage door or gate opener drive. Make sure
that neither your vehicle nor any persons/
Features
239
Stowing
and
features
Z
Summary of Contents for Mercedes-AMG GT 2015
