Mercedes-Benz EQS 2021, Operator'S Manual

Page: 361 / 928

Blind Spot Assist and Active Blind Spot Assist
▌ Function of Blind Spot Assist and Active Blind
Spot Assist with exit warning
Blind Spot Assist and Active Blind Spot Assist use
radar sensors to monitor the area up to 40 m
behind and 3 m next to your vehicle.
The system can detect vehicles travelling from
speeds of approximately 12 km/h and issue a
warning if they move into the monitoring range.
Status display in the driver's display
¸
Grey: the system is activated but inopera-
tive.
¸
Green: the system is activated and opera-
tional.
Driver's display in the Assistance menu
If a vehicle is detected at speeds above approx-
imately 12 km/h and this vehicle enters the moni-
toring range immediately afterwards, the warning
lamp in the corresponding outside mirror lights up
red. In the Assistance menu, the lamp in outside
mirror 1 also lights up red, and the lane in which
the vehicle is detected is hatched out.
If a vehicle is detected in the monitoring range
and you switch on the turn signal indicator in the
corresponding direction, a double warning tone
sounds once and the warning lamp flashes red in
the corresponding outside mirror. Red radar
waves 2 are displayed next to your vehicle in the
assistance graphic.
If the turn signal indicator remains on, the display
in the outside mirror flashes for all other detected
vehicles, but no further warning tone sounds. If
you overtake a vehicle quickly, no warning is
given.
Observe the notes on driving systems and your
responsibility; you may otherwise fail to recognise
dangers (
/
page 315).
&
WARNING Risk of accident despite Blind
Spot Assist
Blind Spot Assist does not react to vehicles
approaching and overtaking you at a greatly
different speed.
Blind Spot Assist cannot warn drivers in this
situation.
#
Always pay careful attention to the traffic
situation and maintain a safe distance at
the side of the vehicle.
Driving and parking 359
ohne