Mercedes-Benz CLK Coupe 320, Operator'S Manual

Page: 201 / 408

Panorama roof with power tilt/sliding panel (sedan)
199
Closing/Lowering
X
Move the roof panel switch to the
resistance point in direction of arrow
2
or
4
.
X
Release the roof panel switch when the
desired position is reached.
Synchronizing
The tilt/sliding panel and roller sunblinds
must be synchronized
R
after the battery has been disconnected or
discharged
R
after a malfunction
R
if the tilt/sliding panel does not open
smoothly
! Do not attempt to open the tilt/sliding
panel before the tilt/sliding panel is
properly synchronized. The tilt/sliding
panel could otherwise lock-up in the open
position.
If the tilt/sliding panel cannot be closed or
synchronized, contact an authorized
Mercedes-Benz Center or call Roadside
Assistance.
X
Vehicles with SmartKey: Remove the
SmartKey from the starter switch.
X
Vehicles with KEYLESS-GO: Switch off the
ignition and open the driver’s door (this
puts the starter switch in position
0, same
as with the SmartKey removed from the
starter switch). The driver’s door then can
be closed again.
X Remove the respective fuse from the fuse
box (
Y
page 375).
X
Reinsert the fuse in the fuse box.
X
Switch on the ignition.
X Push and hold the roof panel switch in
direction of arrow
3
(
Y
page 198) until the
roller sunblinds are fully extended.
X
Keep holding the roof panel switch in
direction of arrow
3
(
Y
page 198) for
approximately 1 second.
X
Pull and hold the roof panel switch in
direction of arrow
2
(
Y
page 198) until the
roller sunblinds are fully retracted.
X
Keep holding the roof panel switch in
direction of arrow
2
(
Y
page 198) for
approximately 1 second.
X
Press and hold the roof panel switch in
direction of arrow
1
(
Y
page 198) until the
tilt/sliding panel is fully raised.
X
Keep holding the roof panel switch in
direction of arrow
1
(
Y
page 198) for
approximately 1 second.
X
Push and hold the roof panel switch in
direction of arrow
3
(
Y
page 198) until the
tilt/sliding panel is fully closed.
X
Keep holding the roof panel switch in
direction of arrow
3
(
Y
page 198) for
approximately 1 second.
X
Check the express operation feature of the
tilt/sliding panel (
Y
page 198).
If the tilt/sliding panel opens completely,
the roof is synchronized. Otherwise repeat
the above steps.
Controls in detail
Z