Mercedes-Benz Citan 2015, Operating Instructions Manual

Page: 202 / 216

If these devices are linked to functions associ-
ated with resistance to interference, they must
have type approval. This applies to the device or
its interfaces to the vehicle electronics, e.g.
charging brackets.
The type approval document must adhere to
either Directive 72/245/EEC or Regulation
ECE-R 10, each according to the currently appli-
cable version. The type-approved device must
bear the e/E mark. The e/E mark can be
obtained from the equipment manufacturer or
an authorised testing centre.
Devices not linked to functions associated with
resistance to interference do not require type
approval. However, these devices must have a
declaration of compliance for the maintenance
of certain limiting values, according to Directive
89/336/EEC or Directive 1995/5/EC. These
limiting values are defined in Appendix I of the
currently valid version of the Directive
72/245/EEC.
A telephone or two-way radio to be installed in
the vehicle must be approved. You can obtain
further information from any Mercedes-Benz
Service Centre.
When using mobile phones and two-way radios,
Mercedes-Benz recommends connection to an
approved exterior aerial. This is the only way to
ensure optimal reception quality in the vehicle
and to minimise potential interference between
the vehicle electronics and mobile phones or
two-way radios.
The transmission output of the mobile phone or
two-way radio must not exceed the following
maximum transmission output (PEAK).
Frequency range Maximum trans-
mission output
(PEAK)
Short wave
(f < 50 MHz)
100 W
4 m waveband 30 W
2 m waveband 50 W
Channel group com-
munication/Tetra
35 W
70 cm waveband 35 W
GSM 900/AMPS 10 W
GSM 1800 10 W
UMTS 10 W
Identification plates
Vehicle identification plate with vehi-
cle identification number
X Open the front door on the right-hand side.
You will see vehicle identification plate
:
with the vehicle identification number (VIN)
and the permissible weight data.
Vehicle identification plate (example)
:
Vehicle identification plate
;
Vehicle manufacturer
=
EC type-approval number
?
Vehicle identification number (VIN)
A
Maximum permissible gross weight
B
Maximum permissible gross weight of vehi-
cle/trailer combination
C
Maximum permissible front axle load
D
Maximum permissible rear axle load
E
Check-control number
F
Additional homologation information
G
Headlamp setting
H
Flue gas coefficient
I
Paint code
i The data shown on the vehicle identification
plate is sample data. This data differs for
every vehicle and may deviate from what is
200
Identification plates
Technical data