
must be positioned vertically, directly under
the jacking point of the vehicle.
Observe the following when raising the
vehicle:
R
to raise the vehicle, only use the vehicle-
specific jack that has been tested and
approved by Mercedes-Benz. If the jack is
used incorrectly, it could tip over while the
vehicle is raised.
R
the jack is designed only to raise and hold
the vehicle for a short time while a wheel
is being changed. It is not suitable for per-
forming maintenance work under the vehi-
cle.
R
avoid changing the wheel on uphill and
downhill slopes.
R
before raising the vehicle, secure it from
rolling away by applying the parking brake
and positioning wheel chocks. Do not
release the parking brake while the vehicle
is raised.
R
the jack must be placed on a firm, flat and
non-slip surface. On a loose surface, a
large, flat load-bearing underlay must be
used. On a slippery surface, a non-slip
underlay must be used, e.g. rubber mats.
R
do not use wooden blocks or similar
objects as a jack underlay. Otherwise, the
jack will not be able to achieve its load-
bearing capacity due to the restricted
height.
R
make sure that the distance between the
underside of the tyres and the ground does
not exceed 3 cm.
R
never place your hands or feet under the
raised vehicle.
R
do not lie under the vehicle.
R
do not start the engine when the vehicle is
raised.
R
do not open or close a door or the boot lid
when the vehicle is raised.
R
make sure that no persons are present in
the vehicle when the vehicle is raised.
Vehicles with steel wheels and wheel
trim: the wheel trim covers the wheel bolts.
Before you can unscrew the wheel bolts, you
must remove the hub cap.
Steel wheel with wheel trim
X
Using both hands, carefully reach into two
wheel trim openings and remove the wheel
trim.
Vehicles with light-alloy wheels and hub
caps: the wheel bolts are covered by a hub
cap. Before you can unscrew the wheel bolts,
you must remove the hub cap. Two different
variants can be fitted.
Light-alloy wheel with plastic hub cap
Vehicles with plastic hub cap:
X
To remove: turn the centre cover of hub
cap
:
anti-clockwise and remove.
X
To fit: before fitting, ensure that hub cap
:
is in the open position. To do so, turn the
centre cover anti-clockwise.
440
Changing a wheel
Wheels
and
tyres
Summary of Contents for C-Class
