Mercedes-Benz 320 SE, Operator'S Manual

Page: 107 / 157

107
4. Remove lug wrench (1) and
extension (2) from tool kit and
assemble. Loosen but do not
yet remove the wheel bolts.
5. Remove the protective cover
from the jack support tube
opening by inserting a screw
driver in the opening and prying
it out.
The tube openings are located
directly behind the front wheel
housings and in front of the rear
wheel housings.
6. Insert jack arm fully into the tube
hole up to the stop. Place jack on
firm ground. Position the jack so
that it is always vertical (plumb-
line) as seen from the side (see
arrow), even if the vehicle is parked
on an incline.
7. Jack up the vehicle until the
wheel is clear of the ground.
Never start engine while vehicle
is raised.
8. Unscrew upper-most wheel bolt
and install alignment bolt (1)
supplied in the tool kit. Remove
the remaining bolts. Keep bolt
threads protected from dirt and
sand.
9. Remove wheel. Grip wheel
from the sides. Keep hands
from beneath the wheels.