X
Do not remove any foreign objects which
have penetrated the tire, e.g. screws or
nails.
X
Remove the tire sealant bottle, the accom-
panying TIREFIT sticker and the tire infla-
tion compressor from the stowage well
underneath the trunk floor (
Y
page 292).
X
Affix part
:
of the TIREFIT sticker within
the driver's field of vision.
X
Affix part
;
of the TIREFIT sticker near the
valve on the wheel with the defective tire.
X
Remove filler hose
B
and plug
=
from the
bottom section of the tire inflation com-
pressor housing.
X
Slide the yellow filler hose connector into
the mounting on yellow cap
A
of tire seal-
ant bottle
:
until the plug engages.
X
With the sealing rings in front, slide yellow
cap
A
of tire sealant bottle
:
into the
mounting of tire inflation compressor
;
.
The cap must engage in both hooks.
X
Remove the cap from valve
C
on the faulty
tire.
X
Screw filler hose
D
onto valve.
X
Insert plug
=
into the socket of the ciga-
rette lighter (
Y
page 260) or into a 12 V
power socket in your vehicle (
Y
page 261)
X
Turn the SmartKey to position 1 in the igni-
tion lock (
Y
page 139).
X
Press on/off switch
?
on the tire inflation
compressor to ON.
The tire inflation compressor is switched
on. The tire is inflated.
i
First, tire sealant is pumped into the tire.
The pressure can briefly rise to approx-
imately 500 kPa (5 bar/73 psi).
Do not switch off the tire inflation com-
pressor during this phase.
X
Let the tire inflation compressor run for a
maximum of ten minutes. The tire should
then have attained a pressure of at least
200 kPa (2.0 bar/29 psi).
If a tire pressure of 200 kPa (2.0 bar/29 psi)
is achieved after a maximum of ten minutes,
see (
Y
page 296).
If a tire pressure of 200 kPa (2.0 bar/29 psi)
is not achieved after a maximum of ten
minutes, see (
Y
page 295).
i
If tire sealant leaks out, allow it to dry. It
can then be removed like a layer of film.
If your clothes are soiled with tire sealant,
have them cleaned with perchloroethylene
at a dry cleaner as soon as possible.
Tire pressure not reached
If a tire pressure of 200 kPa (2.0 bar/29 psi)
has not been achieved after ten minutes:
X
Switch off the tire inflation compressor.
X
Unscrew the filler hose from the valve of
the faulty tire.
X
Very slowly drive forwards or reverse
approximately 30 ft (10 m).
X
Pump up the tire again.
Flat tire
295
Breakdow
n
assi
stanc
e
Z
Summary of Contents for 2015 SLK
