Mercedes-Benz 2013 CLS Coupe, Owner'S Manual

Page: 162 / 424

Pulling away
Automatic transmission
G
WARNING
If the engine speed is above the idling speed
and you engage transmission position
D or
R, the vehicle could pull away suddenly. There
is a risk of an accident.
When engaging transmission position
D or R,
always firmly depress the brake pedal and do
not simultaneously accelerate.
X
Depress the brake pedal and keep it
depressed.
X
Shift the transmission to position D or R.
X
Release the parking brake (
Y
page 181).
X
Release the brake pedal.
X
Carefully depress the accelerator pedal.
i
It is only possible to shift the transmission
from position P to the desired position if
you depress the brake pedal. Only then is
the parking lock released.
i The vehicle locks centrally once you have
pulled away. The locking knobs in the doors
drop down.
You can open the doors from the inside at
any time.
You can also deactivate the automatic lock-
ing feature (
Y
page 258).
i Upshifts take place at higher engine
speeds after a cold start. This helps the
catalytic converter to reach its operating
temperature more quickly.
Hill start assist
G
WARNING
After a short time, hill start assist will no lon-
ger brake your vehicle and it could roll away.
There is a risk of an accident and injury.
Therefore, quickly move your foot from the
brake pedal to the accelerator pedal. Never
leave the vehicle when it is held by hill start
assist.
Hill start assist helps you when pulling away
forwards or in reverse on an uphill gradient.
It holds the vehicle for a short time after you
have removed your foot from the brake pedal.
This gives you enough time to move your foot
from the brake pedal to the accelerator pedal
and depress it before the vehicle begins to
roll.
X
Take your foot off the brake pedal.
The vehicle is then held for about a second.
X
Pull away.
Hill start assist will not function if:
R
you are pulling away on a level road or a
downhill gradient.
R
the transmission is in position N.
R
the parking brake is applied.
R
ESP
®
is malfunctioning.
ECO start/stop function
Introduction
The ECO start/stop function switches the
engine off automatically if the vehicle is stop-
ped under certain conditions.
When pulling away again, the engine starts
automatically. The ECO start/stop function
thereby helps you to reduce the fuel con-
sumption and emissions of your vehicle.
Important safety notes
G
WARNING
If the engine is switched off automatically and
you exit the vehicle, the engine is restarted
automatically. The vehicle may begin moving.
There is a risk of accident and injury.
If you wish to exit the vehicle, always turn off
the ignition and secure the vehicle against
rolling away.
160
Driving
Driving and parking