X
Using lug wrench
:
, loosen the bolts on
the wheel you wish to change by about one
full turn. Do not unscrew the bolts
completely.
The jacking points for the jack are located
behind the wheel housings of the front wheels
and in front of the wheel housings of the rear
wheels (arrows).
The jack is designed exclusively for jacking up
the vehicle at the jacking points. The jack
saddle must be placed centrally under the
jacking point.
If you do not position the jack correctly in the
jacking point, the vehicle can fall off the jack
and seriously or fatally injure you or others.
!
The jack is designed exclusively for
jacking up the vehicle at the jacking points.
Otherwise, your vehicle could be damaged.
X
Position jack
=
at jacking point
;
.
X
Make sure that the base of the jack is
positioned directly under the jacking point.
X
Turn crank
?
clockwise until jack
=
sits
completely on jacking point
;
and the
base of the jack lies evenly on the ground.
X
Turn crank
?
until the tire is raised a
maximum of 1.2 inches (3 cm) off the
ground.
X
Unscrew the wheel bolts.
!
Do not place wheel bolts in sand or on a
dirty surface. The bolt and wheel hub
threads could otherwise be damaged when
you screw them in.
X
Remove the wheel.
Flat tire
257
Breakdown assistance
BA 204 USA, CA Edition A 2011; 1; 5, en-US
hereepe
Version: 3.0.3.6
2010-05-20T09:17:30+02:00 - Seite 257
Z
