On vehicles with KEYLESS-GO, press the
Start/Stop button twice (
X
Check the coolant temperature display in
the instrument cluster.
The coolant temperature must be below
158 ‡ (70 †).
In order to avoid any potentially serious burns:
R
use extreme caution when opening the
hood if there are any signs of steam or
coolant leaking from the cooling system, or
if the coolant temperature display indicates
that the coolant is overheated.
R
do not remove the pressure cap on the
coolant reservoir if the coolant temperature
is above 158 ‡ (70 †). Allow the engine to
cool down before removing the cap. The
coolant reservoir contains hot fluid and is
under pressure.
R
using a rag, slowly turn the cap
approximately
1
/
2
turn to relieve excess
pressure. If opened immediately, scalding
hot fluid and steam will be blown out under
pressure.
R
do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts.
X
Slowly turn cap
:
half a turn counter-
clockwise and allow excess pressure to
escape.
X
Turn cap
:
further counter-clockwise and
remove it.
If the coolant is at the level of marker bar
=
in the filler neck when cold, there is
enough coolant in coolant expansion
tank
;
.
If the coolant is approximately 0.6 in
(1.5 cm) higher when warm, there is
enough coolant in coolant expansion
tank
;
.
X
If necessary, add coolant which has been
tested and approved by Mercedes-Benz.
X
Replace cap
:
and turn it clockwise as far
as it will go.
For further information on coolant, see
(
Windshield washer system/headlamp
The washer fluid reservoir is used for both the
windshield washer system and the headlamp
cleaning system.
Washer solvent/antifreeze is highly
flammable. Do not spill washer solvent/
antifreeze on hot engine parts, because it may
ignite and burn. You could be seriously
burned.
!
At temperatures below freezing, always
fill the washer fluid container with a mix of
windshield washer concentrate and
antifreeze additive. There is otherwise a
risk of damaging the windshield washer
system/headlamp cleaning system.
!
Only use washer fluid concentrate which
is suitable for plastic lenses. Unsuitable
washer fluid concentrate could damage the
plastic lenses of the headlamps.
!
Do not add distilled or de-ionized water to
the washer fluid container. Otherwise, the
Engine compartment
241
Maintenance and care
BA 204 USA, CA Edition A 2011; 1; 5, en-US
hereepe
Version: 3.0.3.6
2010-05-20T09:17:30+02:00 - Seite 241
Z
