Mercedes-Benz 2009 SLK 300, Operator'S Manual

Page: 219 / 364

Useful features
217
Programming tips
If you are having difficulty programming the
integrated remote control, here are some
helpful tips:
R
Check the frequency of hand-held remote
control
5
(typically located on the reverse
side of the remote). The integrated remote
control is compatible with radio-frequency
devices operating between 280-390 MHz.
R
Put a new battery in hand-held remote con-
trol
5
. This will increase the likelihood of
the hand-held remote control sending a
faster and more accurate signal to the inte-
grated remote control.
R
While performing step 3, hold hand-held
remote control
5
at different lengths and
angles from the signal transmitter button
(
2
,
3
or
4
) you are programming.
Attempt varying angles at the distance of 2
to 12 inches (5 to 30 cm) away or the same
angle at varying distances.
R
If another hand-held remote control is avail-
able for the same device, try the program-
ming steps again using that other hand-
held remote control. Make sure new
batteries are in the hand-held remote con-
trol before beginning the procedure.
R
Straighten the antenna wire from the
garage door opener assembly. This may
help improve transmitting and/or receiving
signals.
i Certain types of garage door openers are
incompatible with the integrated remote
control. If you should experience further
difficulties with programming the inte-
grated remote control, contact an author-
ized Mercedes-Benz Center, or call Mer-
cedes-Benz Customer Assistance Center
(in the USA) at 1-800-FOR-MERCedes, or
Customer Service (in Canada) at
1-800-387-0100.
i USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
i Canada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions:
1. This device may not cause interference,
and
2. this device must accept any interfer-
ence received, including interference
that may cause undesired operation of
the device.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
Controls in detail