Mercedes-Benz 2009 CLS 550, Operator'S Manual

Page: 124 / 356

Control system
122
Resetting trip odometer
X
Make sure you are viewing the standard
display (
Y
page 126) in the multifunction
display.
X
Press and hold the reset button in the
instrument cluster (
Y
page 120) until the
trip odometer is reset.
Tachometer
The red marking on the tachometer
(
Y
page 30) denotes excessive engine speed.
! Avoid driving at excessive engine speeds,
as it may result in serious engine damage
that is not covered by the Mercedes-Benz
Limited Warranty.
To help protect the engine, the fuel supply is
interrupted if the engine is operated within
the red marking.
Control system
Introduction
The control system is activated as soon as the
starter switch is in position
1 (
Y
page 83).
The control system enables you to call up
information about your vehicle and to change
vehicle settings.
For example, you can use the control system
to find out when your vehicle is next due for
maintenance service, to set the language for
messages in the instrument cluster display,
and much more.
G
Warning!
A driver’s attention to the road and traffic
conditions must always be his/her primary
focus when driving.
For your safety and the safety of others,
selecting features through the multifunc-
tion steering wheel should only be done by
the driver when traffic and road conditions
permit it to be done safely.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approxi-
mately 14 m) every second.
The control system relays information to the
multifunction display.
Multifunction steering wheel
The displays in the multifunction display and
the settings in the control system are con-
trolled by the buttons on the multifunction
steering wheel.
Controls in detail