Mercedes-Benz 2007 G 500, Operator'S Manual

Page: 402 / 457

401
Practical hints
Towing the vehicle
왔
Towing the vehicle
Mercedes-Benz recommends that the
vehicle be transported with all wheels off
the ground using flatbed or appropriate
wheel lift/dolly equipment. This method is
preferable to other types of towing. When circumstances do not permit the
recommended towing methods, the
vehicle may be towed with all wheels on
the ground only so far as necessary to have
the vehicle moved to a safe location where
the recommended towing methods can be
employed.
!
Use flatbed or wheel lift/dolly equipment,
with SmartKey in starter switch turned to
position
0 .
Do not tow with sling-type equipment. Towing
with sling-type equipment over bumpy roads will
damage radiator and supports.
To prevent damage during transport, do not tie
down vehicle by its chassis or suspension parts.
Use the towing eyes.
Switch off the ESP
®
(
컄
page 94), the tow-away
alarm (
컄
page 98) and the automatic central
locking (
컄
page 155).
!
Do not tow-start the vehicle.
!
When towing the vehicle with all wheels on
the ground, the gear selector lever must be in
neutral position
N and the SmartKey must be in
starter switch position 2 .
When towing the vehicle with all wheels on the
ground, the vehicle may be towed only for
distances up to 30 miles (50 km) and at a speed
not to exceed 30 mph (50 km/h).
If the vehicle is towed with one axle raised
(observe instructions regarding flexible drive
shaft and propeller shafts), the engine must be
shut off and the SmartKey must be in starter
switch position
1 . Otherwise, the 4-ETS may
become engaged which may cause loss of
towing control.
Warning!
G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:
앫
the engine will not run
앫
there is a malfunction in the brake sys-
tem
앫
there is a malfunction in the power
supply or in the vehicle’s electrical
system
This is necessary to adequately control the
towed vehicle.
Prior to towing the vehicle with all wheels on
the ground, make sure the SmartKey is in
starter switch position 2 .
If the SmartKey is left in the starter switch
position 0 for an extended period of time, it
can no longer be turned in the switch. In this
case, the steering is locked. To unlock,
remove SmartKey from starter switch and
reinsert.