6) Define the position of the swaging blocks and place them on the same
position. Them install the pipe between the swaging blocks and lower the
upper plate.
(Fig. 10). (Fig. 11)
Pipe
installed.
Fig. 10
Fig. 11
Upper plate lowered.
7)
Electric-Hydraulic Model:
Close the piston relief valve
(Fig. 12)
, turn motor on
(Fig. 13).
Turn valve to
“pressure”,
making hydraulic cylinder move towards the
pipe.
(Fig. 14).
To stop cylinder motion, turn valve back to initial position and open
relief valve.
Fig. 12
Fig. 13
Fig. 14
Piston relief valve.
Motor On/Off
switch
Pressure Valve
control switch.
8)
Pneumatic-Hydraulic model:
Loosen the nut beside the pneumatic motor,
close relief valve and pull the pneumatic motor trigger
(Fig. 15),
making cylinder
ram move forward; to move back use relief valve.
Fig. 15
Relief valve
Pneumatic drive trigger
5
