Place the machine on a flat floor. Settle it adjusting the feet by the special key supplied with the
machine.
Leave enough space around the machine to facilitate working operations and maintenance.
ELECTRICAL CONNECTION
Check that the power supply has the same rating as indicated on the machine identification plate.
The power supply must be through a capacity disconnecting-switch sized to the power requirements of the
machine and with a three phase socket with 4 contacts (3 ground) or a 3 contacts socket (2
ground) according to the voltage of the machine. Connect to the terminal board of the electrical panel. Before
power is switched on, make sure no loose connections are present due to vibrations during transportation.
Connections must comply with standards in force in the country where the machine is installed.
MACHINE DESCRIPTION
The divider rounder has been designed to divide and round dough divisions as per quantities quoted in the
technical data. The machine is suitable to work bread dough, pizza and flour sweets. All the parts in contact with
dough are in stainless steel or food material. The divider rounder must be placed in rooms with a temperature not
higher than 25°C.
1) Cutting hydraulic cylinder
2) Two cylinders for pressing
3) Control board
FIRST START UP AND TEST
The following operations must be carried out by the personnel making electrical connections.
1) Turn the selector 5 (FIG.3) to start the machine. At this point it appears for some seconds the version of
the installed software.
2) Wait for the flashing of the push-button CLEAN 3 ( FIG.2)
3) Reset by pushing at the same time the start push-buttons 1 (FIG.2) until the end of the push button
“CLEAN” flashing. OPERATION TO REPETE at every re-start.
4) To verify that the plate rotation direction is the one indicated by the arrow ( clockwise ) :
Start again by pushing at the same time the two start push-buttons 1 (FIG. 2). If the working cycle does
not start and lowering the rounding lever (4) ( after the flashing of the push-button CLEAN 3 (FIG.2) the
plate turns anticlockwise so not in the correct direction switch off the machine , cut off the electricity and
reverse the two power supply phases.
1
2
2
3
4
The electrical connection must be carried out by qualified personnel.
1
2
2
4
Check that the power supply corresponds to the machine voltage and connect the plug to the electrical plant.
Open the safety door and verify that inside the machine there is not any foreign body.
