EN
28
INSTALLATION
UNPACKING
• Remove tape and any stickers from the
freezer before use (except for type plate).
• Rub off any residual glue with your
fingers, or with a little detergent. Wipe
with warm water and then wipe dry.
• Do not use sharp objects or flammable or
abrasive detergent, this can damage the
surface of the freezer.
• Do not tilt the freezer more than 45°
when moving.
WARNING!
At least two persons are needed to lift the
freezer, otherwise there is a risk of personal
injury.
SPACE REQUIREMENT
• Leave at least 200 mm of free space on
each side, 200 mm behind and 300 mm
above the freezer, to ensure adequate
ventilation.
• If the freezer is placed adjacent to a wall,
leave enough space to open the door.
• Do not put the freezer near a source of
heat, or in direct sunlight.
WARNING!
Keep flammable substances and fumes,
such as petrol, away from the freezer – risk
of explosion, fire, death and/or serious
personal injury.
ELECTRICAL DATA
• Failure to follow all the instructions and
safety instructions can lead to the risk of
electric shock, fire, serious personal injury
and/or material damage.
• Check that the mains voltage corresponds
to the rated voltage on the type plate.
WARNING!
The plug must be plugged into a correctly
installed earthed power point. Never modify
the plug in any way. Do not use an extension
cord or plug adapter, or the equivalent.
Electrical connection
• The freezer must only be connected to a
correctly earthed power point, 220–240
VAC, 50 Hz, with a mains fuse of 10 A.
• The freezer should be connected to a
separate circuit.
• Do not connect the freezer to a power
point that can be switched off.
• Do not use an extension cord.
NOTE:
Pull out the plug before installation. When
ready, plug in the plug and adjust the
settings.
LEVELLING
• It is very important that the freezer is
levelled on installation, otherwise the
door might not close properly which can
cause inadequate cooling or problems
with frosting or moisture.
• Turn the levelling foot clockwise to raise
the level or anticlockwise to lower it.
PUT ON THE DOOR
1. Pull out the plug and empty the freezer.
2. Adjust the two levelling feet to the highest
position.
3. Undo the screws that hold the top plate
with a Phillips screwdriver and lift off the
top plate.
FIG. 2
4. Undo the screws that hold the top hinge
with a Phillips screwdriver.
FIG. 3
