.The adjusting ring does not lock when the pointer is positioned only halfway between the graduations.
.Do not operate the tool with the adjusting ring set between the number 18 and the
marking. The tool may be damaged.
..Always be sure that the tool is switched off and the battery cartridge is removed before carrying out
any work on the tool.
.Hold the ring and turn the sleeve counterclockwise to open the chuck jaws. place the bit in the chuck as far as it
will go.Hold the ring firmly and turn the sleeve clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve counter-clockwise.
Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then
increase the speed gradually. Release the switch trigger as soon as the clutch cuts in.
Place the point of the driver bit in the screw head and apply
pressure to the tool. Start the tool slowly and then increase
the speed gradually. Release the switch trigger as soon as
the clutch cuts in.
.Make sure that the driver bit is inserted straight in the screw
head, or the screw and/or bit may be damaged.
.When driving wood screws, pre drill pilot holes to make
driving easier and to prevent splitting of the workpiece.
See the chart.
.First, turn the adjusting ring, so that the pointer points to
the marking. Then proceed as follows.
When drilling in wood, the best results are obtained with wood
drills equipped with a guide screw. The guide screw makes
drilling easier by pulling the bit into the workpiece.
To prevent the bit from slipping when starting a hole, make an
indentation with a center-punch and hammer at the point to
be drilled.
Place the point of the bit in the indentation and start drilling.
Use a cutting lubricant when drilling metals. The exceptions
are iron and brass which should be drilled dry.
Summary of Contents for ED-LS1
Page 1: ......
