2
Place the table leg standing on the top
bracket, so that the top bracket is facing
the ground/floor. Remove the transport
protection by loosening the three screws.
**Route the cord through the leg and pull
it up so that it fits the table leg. Make sure
the cord is positioned correctly, so that it
is located directly next to the hole in the
foot. Fasten the foot with the 3 screws and
washers.*
***Install the tabletop with four screws and
washers. Turn then the Statio table correctly
and reconnect power. You are now ready to
enjoy your new Mensa Heating product.
3
AUS
/NZ
*PLEASE NOTE: To ensure the product is properly tightened, please tighten all screws twice.
**Model without serial connection.
***If purchase with a Mensa Heating table top.
