background image

MENNEKES 

LockOUT-LET

PIN & SLEEVE INTERLOCKED RECEPTACLE

READ BEFORE INSTALLING ANY 

LockOUT-LET

 DEVICE

WARNING: TURN OFF ALL POWER SUPPLIES

 TO 

RECEPTACLE BEFORE INSTALLING OR 
SERVICING.

NOTICE:

Suitable for use on a circuit capable of 
delivering not more than 10,000 RMS 
symmetrical amperes at the voltage rating of the 
receptacle.

NOTICE:

Separate overcurrent protection must be 
provided.

NOTICE:

USE COPPER CONDUCTORS ONLY with a 
75° min. insulation rating.  Size conductors for 
75° ampacity.

CAUTION:

UNIT IS NOT GROUNDED

.  Hubs entering the 

enclosure must be electrically connected to a 
grounding terminal block.

LockOUT-LET devices feature a pin &
sleeve receptacle prewired to a load
rated disconnect switch.  The
receptacle is interlocked requiring the
switch to be in the OFF position to
insert or remove a like rated plug.  The
enclosure is rated NEMA 4X;12 for
both indoor and outdoor use.  The
switch handle has a padlock provision
as a method of compliance to OSHA
Lockout/Tagout Regulations.

INFORMATION

TO REMOVE OR REPLACE COVER

Fully loosen screws (do not remove) located in four corners of cover.  Pull top of cover away
from bottom box and slide down.  To replace cover, reverse above procedure.  Slight wiggle of
cover and switch handle may be needed to position cover.  

DO NOT FORCE.  SWITCH MUST BE IN OFF POSITION TO REPLACE COVER

.

MOUNTING

SEE DIAGRAMS BELOW for mounting dimensions and installation of mounting feet.

Enclosure can be mounted with either external mounting feet (attach using rear rivets) or 

direct mounted through mounting tubes (located near cover rivets in corners).

Screws recommended for direct mounting:  #10.

Mount unit on a secure flat vertical surface with the receptacle facing down.

Tighten four cover screws 25 lb-in.  DO NOT OVER TORQUE.

SEE SEPARATE CONDUIT
CONNECTION AND GROUNDING
INSTRUCTIONS IN GROUND/HUB
KIT.

DO NOT MOUNT

THROUGH REAR WALL

OF BOX

8.535”

7.016”

11.654”

TOP

10.736”

7.593”

4.815”

6.004”

DO NOT MOUNT

THROUGH REAR WALL

OF BOX

11.173”

7.350”

14.291”

TOP

13.374”

8.268”

 5.150”

6.339”

11.496”

8.858”

30A

60A

Reviews: