06
Earthing the
Equipment
• Correct earthing of the concrete mixer is vitally important in reducing
the risk of electrical shocks;
• Thus, before switching on your concrete mixer, make sure that the
socket has an earth pin and that this is correctly installed. If your socket
is not earthed, arrange for an earth to be installed before using the
concrete mixer;
• Should use copper rod length and recommended depth of 2 meters;
• The ground wire to pass through the on / off switch should not be
interrupted or connected to contacts.
• Do not connect the ground wire directly into the mixer neutral wire
mains.
• Grounding must be made according to the standards in the region and
accompanied by a responsible qualified function. In the absence of such
standards, should be carried out according to international standards,
doubts when the installation please contact your authorized service;
Operation
Conditions
• Concrete mixers can be used in both indoor and outdoor environments;
• When filling a concrete mixer with a spade, do not place the spade inside
the drum;
• Improper use of this equipment, other than that for which it was projec
-
ted, can pose a physical threat to the operator;
• Read this instruction manual carefully;
• The operator must be trained or qualified to use this equipment;
• Set aside an exclusive area for working with the equipment. Keep this
area clear of obstacles and well lit at all times;
• Whenever performing maintenance on this equipment, disconnect the
cable from the power supply.
• Pneumatic wheel rim 13" calibration: between 26 and 30 p.s.i (pound
force per square inch);
Noise level during operation:
Since the noise level during mixer operation, with the addition of stone
and gravel into the drum to simulate a maximum noise level, can reach up
to 95 decibels, the use of ear protect ion is recommended during prolon
-
ged operation.
Cleaning and
Conservation
• It must be disconnected from the mains and the cleaning operation is
always performed at the end of utilization;
• Cleaning the drum with water, removing any residue of the blades and
all internal and external part of the drum;
• Clean the rack and pinion, removing all abrasive material to compo
-
nents;
• Do not put water on electrical components and engine;
Standardization of
plugs and sockets
32A 220V/380V.
Ground point
existing engine.
Ground point existing machine.
www.discount-equipment.com