Menards MASTERFORCE 245-1932, Operator'S Manual

Page: 6 / 12

Page 5
NECESSARY TOOLS REQUIRED
FOR ASSEMBLY
• 10 mm socket
• 14 mm socket
• Extension ratchet
INSTALL THE HANDLE
Position the handle over the holes and
attach with the M6 x 12 hex bolts. Tighten
securely using a 10 mm socket.
INSTALL THE
POWER CORD
Cut the black strip holding the cord, then
pull the white strip to get the plug out of the
cabinet and through the grommet. Tighten
the grommet.
INSTALL THE CASTERS
NOTE: Two or more people may be required
to complete this step.
Carefully lay the bottom cabinet on its
back using a soft mat under the back for
protection. Position the two swivel casters
on the bottom of the cabinet, on the right
side (same side as the handle). Insert
M8 x 25 hex bolts through washers, then
through the casters and into the bottom
of the cabinet. Tighten securely using a
14 mm socket. Repeat for the two rigid
casters on the other side of the cabinet.
CHEST AND CABINET
CONNECTION
WARNING:
(Where applicable)
When adding a chest, all add-on tops must
be removed from the roller cabinet. Make
sure that both connector brackets are in
place and secure.
NOTE: Two or more people may be required
to complete this step.
Place the chest on the cabinet. Attach the
connectors, making sure the connectors
slide into the openings on the back of the
chest. Fasten the connectors to the back
of the cabinet with screws.
ASSEMBLY AND OPERATION