3.5” Bulldog User Guide
April 10, 2006
page 5 of 13
3.1.4 MOUNTING
The AT3515 may be mounted in any orientation. A total of four bottom and six side
mounting holes are available for installation. The mounting holes require 6-32 screws
with a maximum depth of 0.25 inch.
The diagram given below is valid for all capacities of the AT3515 drive. The overall
outside dimensions are 4 inches (101.6 mm) wide, 5.56 inches (141.22mm) long, and
0.473 inches (12 mm) tall. Please refer to the following drawing for dimensions and
mounting-hole locations.
Figure 2 - Mechanical Dimensions
3.1.5 COMPUTER SETUP
To be recognized by the computer, the drive translation information must typically be
entered into the System Setup or CMOS Setup utility. For non-PC compatible
computers, this may not apply. The AT3515 supports automatic detection and
configuration if offered by the BIOS. If the drive configuration must be manually entered,
select drive type USER and use the table below to determine proper setup parameters.
Automatic CHS translation and LBA mode is supported. Note that a MB is equal to
1024*1024 bytes.