PASSENGER SIDE SPEAKER INSTALLATION
DRIVER’S SIDE SPEAKER INSTALLATION
EXAMPLE OF PROPERLY INSTALLED PODS
STEP 4:
Follow the same steps as above using the “Driver’s Side” template.
WWW.MEMPHISCARAUDIO.COM
Cut out the inside template (driver/passenger) along
the cut line. Position the template on the kick panel
above the foot rest making sure to line up the arrows
on the template to the curves of the vehicle panel as
shown above. Secure the template to the panel with
tape to prevent it from moving. Scribe the 3 points
above. These points will correspond to the threaded
inserts on the back of the appropriate enclosure.
Place the pod on kick panel mounting location. The holes should line up with the threaded inserts in the
enclosure. You will then use the provided M6 screws and washers to loosely tighten the pods in place through
the drilled holes. Once all three screws are loosely threaded, then tighten all three by hand until snug.
STEP 1
Remove the template, locate the 3 scribe marks and
use a 1/4” drill bit to drill holes in each marked
location.
STEP 2:
SPEAKER POD INSTALLATION
WARNING:
These instructions are designed to be used on 2016 and newer Polaris General Models. These pods are designed specifically to work with these types of
machines. If you have a different year or model machine, check with your authorized Memphis Audio dealer or contact Memphis Audio customer service
at 800-489-2300 prior to attempting installation. These kits are not designed to be used with any other model or year vehicle. Attempting to install
these speakers on any other vehicle may result in permanent damage to your vehicle.
STEP 3:
Driver’s Side
Completed Installation
Passenger’s Side
GEN65FE
