Part No. 2320-0085
2. Mounting Instructions, continued
Fig. 1
Fig. 2
1. Place lower slot into lower bushing.
2. Rotate top slot into place.
3. Secure locking Mechanism.
4. Loosen Allen Bolt to adjust angle,
then re-tighten Allen Bolt.
HD Road King FLHR,FLHRI,FLHRCI,1994-2010
Bullet FX Fairing, HD Road King
Mounting kit
Remove the light bar. Remove each rubber grommet
and replace with new bushing assembly that includes
aluminum bushing insert, plastic bushing with O Ring
toward headlight and then stainless steel washer (Fig
3). Refit the light bar. Washer must be between light
bar and bushing assembly. Loosely reinstall acorn nuts.
Note: In some cases where the stud is too short to in-
stall the clutch cable guide it may be necessary to back
out stud by tightening two 5/16” - 18 nuts together on
stud and unscrew one or two turns.
5.
Slip the fairing and the mounting plates onto the upper
and lower bushings, and secure the left and right lock-
ing mechanism. (See Figs 4a and 4b). Tighten all four
light bar acorn nuts.
This is a detachable fairing / windshield, ALWAYS
make sure the Locking Mechanism is fully engaged
after installation (See Fig 5)
Use the slotted holes in the plates to adjust the height
and rake angle for the best fit.
6.
7.
8.
Remove
acorn nuts
Remove
light bar
Acorn nut
Washer
Light bar
Supplied
Washer
Bushing
Headlight
Cover
Side view of
top light bar
mounting
hardware.
Bushing insert
is hidden
O Ring
Fig. 3
Locate the Clutch and Throttle
plates
behind
the light bar bracket,
onto the top and bottom bushings
Fig. 4a
Fig. 4b
1 2 3
4
CORRECT
Fully engaged
Locking mechanism
NOT CORRECT
R322C/T
LATCH
ASSEMBLY
Fig. 5
